custom inlet manifold required

se7ensport · Post by **se7ensport** » Tue May 22, 2007 8:31 pm

Can anyone make one? Alloy or stainless would be fine.

Pinto to GSXR TB's required, the guy who normally makes them on locostbuilders is AWOL

Cheers

Alex

anton · Post by **anton** » Thu Jun 07, 2007 2:43 pm

you could try allard turbosport http://www.allardturbosport.co.uk/

I know lloyd and his tig welding skills are spot on

Post by **Werner Van Loock** » Thu Jun 07, 2007 4:15 pm

I have a .dxf drawing of the pinto manifold plate or whatever it's called. So can get it lasercut about anywhere they have a lasercurring facility and then weld the correct diameter tubes on it.