Rev counter

Cerberus · Post by **Cerberus** » Mon Jun 18, 2007 9:41 pm

As it says, has anyone got one would prefer 95mm 0-7 or 8k will do, i'm getting desperate now and don't want to over rev the motor

Phil

Cerberus · Post by **Cerberus** » Sat Jun 30, 2007 10:10 am

Cerberus wrote:As it says, has anyone got one would prefer 95mm 0-7 or 8k will do, i'm getting desperate now and don't want to over rev the motor

Phil

I have purchased a new one from Weber

Phil

stylussprinter · Post by **stylussprinter** » Sat Jun 30, 2007 12:13 pm

Phil , haven't you got a rev' limiter

Cerberus · Post by **Cerberus** » Sat Jun 30, 2007 1:17 pm

stylussprinter wrote:Phil , haven't you got a rev' limiter

There is one built into the ECU but i don't know what it is set at, i spoke to Weber who said if i sent it back to them

they will set it for me, you can guess what i said, i have a rolling road print out of the engine power and they only ran it upto 6300, anyway having fitted the rev counter the rev limiter doesn't kick in at 6300 so i'm glad i bought one, i will try and fit some ARP bolts before Llandow to strengthen the bottom end

.
Roll on tomorrow

Phil

stylussprinter · Post by **stylussprinter** » Sat Jun 30, 2007 4:36 pm

Very wise move . At least you then have confidence in the bottom end and a very cheap safety net at 70 quid or so

I would fit them whether the engine was standard or not.
I would have thought that even a 180 ish bhp Vauxall would have a rev' limit of around 7200rpm so no need to worry up to 7000 rpm.

clubstylus

Rev counter

Rev counter

Re: Rev counter

over rev' ?

Re: over rev' ?

ARP's